Products
  Epoxy Clear Primer
Scope :
A two component clear epoxy priming system cured with polyamide provide very though prime coat for subsequent epoxy coating suitable for protection of steel structure in aggressive coastal and industrial atmosphere.

The product has good water, solvent and chemical resistance. The product is specially developed for direct application on steel and concrete surfaces for subsequent epoxy coatings.

Product Data
Type : Two pack Polyamide cured Epoxy Full Curing : 7 days.
Composition : Epoxy resin + additives Drying Time :
TOUCH : 3-4 hours
HARD : 24 hours
Mixing Ratio : Base: Hardner 75:25 Overcoating Interval : MIN : 12 Hours
Pot Life : 3-4 hours Flash Point : Above 25 C
Application : Brush/ Spray Colour : Clear
Recommended DFT : 130-160 microns per coat Finish : Glossy
Covering Rate : 12-15 sq. Mtr./Ltr. Packing : 10Lit. / 20Lit.
Thinner / Clenear : ICO Epoxy Thinner  

Resistance Guide
Chemical Resistance :
EXPOSURES SPLASH & SPLILLAGE MILD FUMES OUTDOOR RESISTANCE
Acids Good Good
Alkalis Good Good
Solvents Good Good
Salt Very Good Very Good
Water Excellent Excellent
 
Temperature Resistance :      Continuous : 90 C
     Intermittent : 110 C
Flexibility :      Moderate
Abrasion Resistance :      Good
Weatherability :      Excellent.

Surface Preparation
 Steel : Remove oil, grease and other contaminants by using degreasing solvent and blastto 2 ½ (Swedish Standard SIS 05 5900) with a surface profile up to 65 microns maximum.
Concrete : Before application insure that the new concrete is cured for 90 days. Clean the surface for oil, laitance and other contaminants and salt deposits by high pressure water hosing and rough it up manually by wire brush to adhesive prime system firmly. Before application insure all dust other particles are fully removed by sunction or air blast and the surface is fully cleaned and dry.

Application
 Stir the base thoroughly and then mix base with hardner to uniform consistency. Allow the mixture to mature of 25 minutes and stir well before and during application.

Brush :  Apply without thinning.

Conventional Spray : Add up to 10% Thinner and use standard equipment at a pressure 3.5-4.9 kg./cm.

Precautions :
 •   Do not overwork as wet
•   Do not apply when temperature falls below 10 C or rises above 50 C and when relative humidity rises above 90%. Do
         not apply during rain, fog or mist.
•   Brushes and spray equipment should be cleaned with Thinner otherwise equipment is likely to be damaged.

Safety :
 As a general rule inhalation of solvent vapors or paint mist, and contact of paint liquid with skin and eyes should be avoided. Forced ventilation should be provided when applying in confined area. In any case skin and eye protection is of at most importance when spraying the paint.

Disclaimer :
 The product information & application details has been given in good faith and as a general guideline. The company does not assume any liability for unsatisfactory results and damage.
 
 
Powerd by : Digital Works